cfe223 vs h335 No Further a Mystery

2 gr H335 and Remington BR primers. Worst accuracy came Together with the CCI #41 primers. I intend to chrono this load through the entire Winter season into the heat of next summer season to determine if something unusal pops up at the end of the temperature extremes. Because it stands the Hornady 55gr FMJ bullet, any LC brass, 26.2 gr H335 and Rem BR primers is my "General Reason" load.

The decapping pin within the sizing die will not be stout plenty of to knock these out devoid of being harmed, so deprime them just before resizing utilizing a special die expressly created for this process.

While in the accompanying data only a few loads exceeded a fifty-grain cost pounds, and were being mainly loaded in conjunction with

You must lookup his posts -- he buys guns and runs them into the outer limitations, wholly intent on destroying all of them within the seek for data and expertise.

I can't consider any blend of powder and caliber where by there might be additional data available.   bluetopper

Burn off fee charts are not for powder substitutions, but are for exhibiting the differences of burn level among powders.

Include to estimate Only demonstrate this consumer #12 · Dec nine, 2015 I employed some back Once i couldn't obtain/get W748 in my 17Rem and it killed a lot of foxes for me. Have not got my loading records listed here with me so simply cannot provide a load.

Personally, my experience and view of the two powders has long been virtually the alternative of yours. CFE 223 will execute improved the more time your barrel is as well as heavier the bullet you use. My feelings are that CFE 223 is true within the verge read more of becoming also gradual of a powder to even use in 223.

I also had some difficulties with the rapidly H335 powder cycling the action so I failed to go after tests the H335 Using the Les Baer.

H335 works fantastic with standard tiny rifle primers. My AR likes 25gr less than an ordinary 55gr ball rounds.

By selecting carry on you confirm you have read our data defense facts and approved our standard stipulations.

Incorporate to estimate Only clearly show this consumer #15 · Sep eight, 2016 I remember a more moderen method of chasing ocw was loading yet another earlier max. If you don't have any strain spikes, then it was prompt to go another move to discover if you will get far more velocity for very long vary concentrating on.

Within the article the author did terribly injury his gun (occurred more than 20 years in the past) whilst reaching to get a little bit additional velocity using data previously mentioned the shown data. He stretched the load for the reason that he wasn't receiving the velocity he felt the cartridge was effective at. In stepping up the charge in one/2 grain increments, the load amount prior to the harmful one particular, knocked the the magazine go over open and he disregarded that only to go to the following phase and set back the lugs over the rifle.

I necessary to discover a more rapidly method of loading, that’s when I commenced using H335. I'd a similar effects you did, utilizing an RCBS powder evaluate, my rates we’re constantly within just 0.1 grain. Making use of H335 I employed thrown rates completely.